Omega Speedmaster cal.1150

Ref: T.Saunders Gasket upside down, slight kink – needs to be replaced. Case clamp screw damaged and floating around along with the case clamp, caused some cosmetic damage to the chronograph plate. Moisture ingress around crown area. Slight corrosion build up and moisture on the stem.
Omega 2500 Co-Axial Watch Repair

Ref: I Dickie The watch movement was sprayed at some point with WD40 and the result is that most of the brass parts have been corroded. Of particular concern was the co-axial escapement parts as these are restricted and not available to purchase. However, the escapement parts were not as affected and after cleaning, turned […]
Repairing a Breitling chronograph pusher.

Ref: O.Godfrey The original brass Breitling pusher was broken and missing. The challenge was to find a replacement. After searching, it proved very difficult to find a suitable replacement and so the decision was made to manufacture a new one.
Breitling Repetition Minutes Circuit Damage

Ref: D.Pollitt After inspection this watch was found to be damaged by slight battery leakage. An attempt was made to clean the contacts but, regretfully, the circuit is a non-starter. The circuit/movement is restricted and cannot be sent to independant watch repairers and so this watch will need to be sent to Breitling. Macro shots […]
Omega Constellation Cal.1020 Watch Service
Ref: R.Finnegan Omega Constellation in a stainless steel case, silver dial and day/date calendar mechanism. Movement: Omega 1020 Automatic Work Required: Full strip down service, rebuild and lubrication.
Omega Seamaster Service – Calibre 562
Ref: P.Stuart Remarks: Timekeeping good. Required stripping and servicing due to lack of lubrication and signs of dirt and debris in the case. Large concentration of old lubrication built up into a paste found in the mainspring barrel.